Jeep Repair Questions

Changing Spark Plugs : 2008 Jeep Patriot

Car Model: 2008 Jeep Patriot
Location: Greensburg, PA Submitted on March 9, 2013

Greensburg, PA

How do you get to the spark plugs to change them?

Rate this Question:


  • Photo
    11 Franklin, MA
    (0) Rated this answer helpful
    This is a pretty basic job . You have to take the plasic  engine cover off. Then you'll see the ignition module/coils in top unplug the wiring harness. Then unbolt it. Carefully remove module. The plugs then can be removed using standard spark plug socket and extension. I recommend to use a high quality plug its only a couple dollars more and totally worth it. Then just put back together. 
    Posted on March 27, 2013

    Need more advice? Ask our experts.

    Other Jeep Related Repair Questions
    • Larry
      Mechanicsville, VA
      dashboard warning lights
      warning lights are all coming on sometimes
      2003 Jeep Liberty | answers (1)
    • lewis
      Middleburg, FL
      my fuel pump fuse keeps blowing I have replaced fuel pump relays check wires ignition module and now after replacing ignition module motor will not turn over
      2000 Jeep Cherokee | answers (0)
    • David
      Lawton, OK
      won't start
      Put new cooling fans and water pump timing is on point but won't start.  It started before i did work i think its the ecm anyway to reset it?
      1996 Jeep Cherokee | answers (1)
    • ray
      Las Vegas, NV
      engine trouble
      car shuts down completely while I'm driving
      1999 Jeep Grand Cherokee | answers (1)
    • J
      West Palm Beach, FL
      Front end noise
      While I am driving, there is continuous squeeking, grinding noises in the steering column/front end of vehicle (especially while turning corners and going over pumps).
      2005 Jeep Liberty | answers (2)
    • Mike
      Dallas, PA
      flex plate and torque converter wont bolt up
      I have a 2003 jeep liberty with a blown 3.7 liter engine I replaced it with a 2002 3.7 liter engine both are vin k . The engine bolts to the tranny but the flex plate wont bolt up to the torque conver...
      2003 Jeep Liberty | answers (1)
    • mary
      The lower radiator hose blows off, no codes, check gauges light comes on, car stutters and stalls.  What is the cause?
      1998 Jeep Grand Cherokee | answers (3)
    • Andy
      Spring Hill, FL
      Trans or engine problem?
      Jeep Cherokee 1998 4.0 6 cyl auto bucks or skips at 50 to 60 mph. Does it 90% of the time when cold. Upon acceleration it stops and takes off. Changed TPS but didn't fix. Can't tell if it's the engine...
      1998 Jeep Cherokee | answers (5)
    • susan
      Brownsville, PA
      Jeep SKIM
      Is it possible to circumvent the skim by installing a remote starter system - and if not, how much will it cost to replace thru dealer...any other fixes available?
      2001 Jeep Grand Cherokee | answers (1)
    • Bruce
      Varnville, SC
      All braking warning lights on
      Suddenly, all the braking warning lights have come on my jeep.  It seems to be operating ok, but the warning lights remain on? The abs switch also is not operating. Ive check the fuse, but it was ok. ...
      2010 Jeep Wrangler | answers (1)
    Shop Photo

    © 2014 | Terms of Service | Privacy Policy