Find:

Location:

Ford Repair Questions

clutch plate is stuck to flywheel : 1975 Ford F-100

Truck Model: 1975 Ford F-100
Location: Shingle Springs, CA Submitted on April 5, 2013

dan
Shingle Springs, CA

1975 datsun 620 pickup unused for 8 yrs.clutch plate appears to be stuck to fly wheel.I replaced the hydralic clucth master and slave. Any simple way to release it??

Rate this Question:

Answers

  • Photo
    Eugene
    11 Franklin, MA
    (0) Rated this answer helpful
    Most likey you'll have to take the transmission out then hammer the clutch off. You can try and see if there is a access plate that you can get a punch in a give the clutch a couple of good hits. 8 years is a very long time who knows what's going on in there and too much effort forcing it may end up with more broken parts.
    Posted on April 05, 2013
    Respond

    Need more advice? Ask our experts.

    Other Ford Related Repair Questions
    • Dean
      Gilbert, AZ
      Fuel problem????
      2001 Ford Ranger 3.0. The engine cranks over and seems to want to start but does not. It has 64,000 miles on it. What is the most likely problem.
      2001 Ford Ranger | answers (1)
    • James
      Brakes
      I have replaced the Master cylinder, pads and shoes, bled the lines 8 times, replaced vac booster, taken it to a mechanic, and the brakes are still spongy.
      What could be wrong?  
      1995 Ford F-350 | answers (2)
    • beth
      Leesburg, FL
      truck wont turn completely over
      We have just tryed everything to get our truck running today it sounds like it wants to start but its not the battery and its not the fuel tank we have checked the water we have checked the oil etc bu...
      1994 Ford F-150 | answers (1)
    • John
      Angleton, TX
      A/C quits cooling when I slow down
      A/C Quits cooling when I slow down. When I stop it may quit for a little bit but when I take off it starts cooling again. I added some Freon system puts out cooler air overall. The low side pressure s...
      2000 Ford F-250 | answers (2)
    • Jeff
      Cherokee, IA
      missfire
      I lost two cylinders while driving down the hiway. Check engine shows 03 and 05 code. I have tried plugs,wires,coils,injectors,cam,compression,cylinder leak down. Any help would be greatly appreciated...
      2004 Ford Ranger | answers (2)
    • Terri
      Terrell, TX
      Loose shifter.....
      Column shifter is loose and slips...  Difficulty shifting
      Approximate cost to fix ... If possible to give an estimate as to how much to fix ?
      1996 Ford F-150 | answers (1)
    • Dennis
      Springfield, OR
      something wrong with this site. question is about ...
      My question is about 05 chev. Not a ford. Something wrong with this site
      1999 Ford Contour SVT | answers (1)
    • Dennis
      Springfield, OR
      hot air coming out of vents
      Intermitent hot air coming out of air vents happens with a/c on or off. No devation in engine temp showing on gauge. If I shut off engine, let it sit just couple minutes then it stops
      1999 Ford Contour SVT | answers (1)
    • Dennis
      Springfield, OR
      sudden intermitent hot air coming from air vents
      Hot air will start coming out of air vents. Happens with a/c on or off. No deviation in engine temp showing on gauge. 
      1999 Ford Contour SVT | answers (1)
    • Clint
      Arroyo Grande, CA
      I need help, can't spot the problem
      Whenever I accelerate up a hill and sometimes even on flats my truck like sputters and hiccups. It can't hold speed going up and the truck jerks. It also makes a loud clank/popping sound. At first I t...
      1999 Ford Contour SVT | answers (0)
    Shop Photo

    © 2014 MechanicAdvisor.com | Terms of Service | Privacy Policy