Find:

Location:

Ford Repair Questions

hood latch stuck : 1996 Ford Explorer

Car Model: 1996 Ford Explorer
Location: Ravenna, OH Submitted on July 29, 2012

bob
Ravenna, OH

hood release doesnt help ,someone helped   hold  lever open while i worked at the hood ,can i use a long screwdriver somehow,i need latch pictures,drawings to better visualize can u help,

Rate this Question:

Answers

This question has not been answered

Need more advice? Ask our experts.

Other Ford Related Repair Questions
  • Donald
    Dallas, TX
    water/antifreez Leak under car between Trans/Oil P...
    Unable TO LOCATE lEAK IS THIS COMMON FOR THIS CAR IT IS A 4X4 2005 EXPLORER THANKS IN ADVANCE
    2005 Ford Explorer | answers (0)
  • jerri
    Camden, SC
    rough idle, cuts off
    cuts back when accelerates
    2003 Ford Taurus | answers (1)
  • Mike
    Camas Valley, OR
    Frustrating engine won't start sometimes!?
    1998 Ford Ranger XLT Splash 2WD V6 4.0 automatic; occassionally won't start for no reason. Battery cranks strong, starter is strong, engine rolls over fine, fuel & spark fine. After trying to start, a...
    1989 Ford Ranger | answers (1)
  • Chuck
    Burbank, CA
    Wont Idle
    The car runs great but when I turn the air conditioner on it starts to surge at idle. Sometime it will stall and other times it will idle high and its feels like its hard to stop when driving because ...
    2004 Ford Focus | answers (0)
  • Bobby
    San Leandro, CA
    Brakes
    I have had 3 sets of front brakes on my car and it still shimmys when u touch the brakes i have been told the tires could be the problem although it stops ok it's just the shimmy.
    2003 Ford Expedition | answers (1)
  • Bernard
    Wichita, KS
    knocking/rattle front of car
    There is a rattle/knocking sound while driving, if I turn the steering wheel left/right the sound stops, could this be a bad tie rod end?
    2000 Ford Taurus | answers (1)
  • john
    Clinton, IA
    why is there no crank no start
    I replaced the gauge pannall in my van, after hooking the gauges up I had no crank no start problem. I put the old gauges back in and still the same problem! the theft light comes on, the fuel gauge d...
    2000 Ford Windstar | answers (2)
  • john
    Clinton, IA
    van will start
    I replaced my cluster gauge in the van, nothing would work, so I put the old one back in and now it won't turn over, fuel pump does not turn on, fuel gauge does nothing. no crank, no start. 
    2000 Ford Windstar | answers (3)
  • jim
    Johnstown, PA
    Solenoid wiring probem
    I removed the firewall starter solenoid/relay wiring to get in from the side, but when it came time to put everything back together.I had forgotten how the wiring worked.When I put the wiring back the...
    2001 Ford F150 Super Cab | answers (1)
  • Photo
    John
    Back-up lights
    The back up lights will not work. I checked the bulbs and they are good. I checked for power in the sockets and there is none. The fuse in the panel is good. What else can I do.
    2000 Ford Mustang | answers (1)
Shop Photo

© 2014 MechanicAdvisor.com | Terms of Service | Privacy Policy