Find:

Location:

Jeep Repair Questions

how to replace ball joint : 1996 Jeep Cherokee

Car Model: 1996 Jeep Cherokee
Location: Troy, NY Submitted on December 9, 2012

Francis
Troy, NY

Rate this Question:

Answers

  • Chris
    11 Gansevoort, NY
    (0) Rated this answer helpful
    On the Jeeps a special ball joint service tool set is required to remove and install the ball joints properly. 
    Posted on December 09, 2012
    Respond
    • Photo
      Eugene
      11 Franklin, MA
      (0) Rated this answer helpful
      I'm sorry was it a jeep Cherokee or a liberty ? 
      Posted on December 09, 2012
      Respond
      • Francis
        11 Troy, NY
        (0) Rated this answer helpful
        how to replace ball joints;1996 jeep liberty
        Posted on December 09, 2012
        Respond

        Need more advice? Ask our experts.

        Other Jeep Related Repair Questions
        • Larry
          Mechanicsville, VA
          dashboard warning lights
          warning lights are all coming on sometimes
          2003 Jeep Liberty | answers (1)
        • lewis
          Middleburg, FL
          electrical
          my fuel pump fuse keeps blowing I have replaced fuel pump relays check wires ignition module and now after replacing ignition module motor will not turn over
          2000 Jeep Cherokee | answers (0)
        • David
          Lawton, OK
          won't start
          Put new cooling fans and water pump timing is on point but won't start.  It started before i did work i think its the ecm anyway to reset it?
          
          1996 Jeep Cherokee | answers (1)
        • ray
          Las Vegas, NV
          engine trouble
          car shuts down completely while I'm driving
          1999 Jeep Grand Cherokee | answers (1)
        • J
          West Palm Beach, FL
          Front end noise
          While I am driving, there is continuous squeeking, grinding noises in the steering column/front end of vehicle (especially while turning corners and going over pumps).
          2005 Jeep Liberty | answers (2)
        • Mike
          Dallas, PA
          flex plate and torque converter wont bolt up
          I have a 2003 jeep liberty with a blown 3.7 liter engine I replaced it with a 2002 3.7 liter engine both are vin k . The engine bolts to the tranny but the flex plate wont bolt up to the torque conver...
          2003 Jeep Liberty | answers (1)
        • mary
          overheating
          The lower radiator hose blows off, no codes, check gauges light comes on, car stutters and stalls.  What is the cause?
          1998 Jeep Grand Cherokee | answers (3)
        • Andy
          Spring Hill, FL
          Trans or engine problem?
          Jeep Cherokee 1998 4.0 6 cyl auto bucks or skips at 50 to 60 mph. Does it 90% of the time when cold. Upon acceleration it stops and takes off. Changed TPS but didn't fix. Can't tell if it's the engine...
          1998 Jeep Cherokee | answers (5)
        • susan
          Brownsville, PA
          Jeep SKIM
          Is it possible to circumvent the skim by installing a remote starter system - and if not, how much will it cost to replace thru dealer...any other fixes available?
          2001 Jeep Grand Cherokee | answers (1)
        • Bruce
          Varnville, SC
          All braking warning lights on
          Suddenly, all the braking warning lights have come on my jeep.  It seems to be operating ok, but the warning lights remain on? The abs switch also is not operating. Ive check the fuse, but it was ok. ...
          2010 Jeep Wrangler | answers (1)
        Shop Photo

        © 2014 MechanicAdvisor.com | Terms of Service | Privacy Policy