Car Model: 2000 Gmc Yukon XL 1500 Location: Comanche, OK Submitted on July 8, 2012
wayne Comanche, OK
5.7 vortec idle is very erratic disconnected throttle position sensor and idle air control, idles and runs fine, replaced both no change. Only codes are random miss fire and vacuum leak at fuel tank, have checked entire vacuum system can not find a leak, replace fuel cap also. Any ideas firstname.lastname@example.org
Rate this Question:
Eugene Franklin, MA
(0) Rated this answer helpful
Look at the mass airflow sensor or the map sensor both will cause the running issue you have talked about. It depends if the code is a lean code or a evap leak code to give any further info
Hi my transfer case seems to squeak at low speeds. Been doing it for a couple years. Just an itritating noise. On the highway it becomes a high pitch whistle sound. What could it be. Its not the driv...
I have a 2009 GMC Acadia. It idles rough when in drive(stopped at lights, etc). I've been told the idle air control valve needs to be cleaned. A tech at Firestone told me it is built in to the thrott...
I have a GMC Jimmy with the 4.3L engine and I have replaced the spark plugs and wires, and the throttle position switch because of a code. I run the vehicle around for about half an hour and then shut...
WHEN I FIRST START MY JIMMY SHE RUNS FINE.MY RADIO,HEATER AND AIR CONDITIONING DOES NOT WORK. AFTER SHE HEATS UP,SHE BEGINS TO MISFIRE, SMELL BAD, AND THE RADIO HEATER AND AIR ALL WORK EXECPT THE AIR ...