Body work and paint service near Lynnwood, WA

I bought my Ford Ranger to Denton Restoration for repair work to the driver's side door and a radiator leak. Both were fixed in a timely matter and a reasonable price. They treated me very well and performed the work as they outlined when the vehicle was dropped off. I highly recommend Denton Restoration for body and mechanical work.

CASCADE COLLISION CENTER IS THE BEST BODY SHOP THERE IS!!! Very professional, HONEST people and they do an amazing job! I have referred all of my family and friends to Cascade Collision Center. Thanks to all of the employees there for making my repair as painless as possible!

I took my 95 Ford f150 here on the recommendation of Discount Tire for an alignment. I had replaced the entire front end linkage and the truck REALLY needed an alignment after that! They did the work as asked. I picked up the truck and they told me that things weren't really aligned because I needed a new pitman arm. I told them I'd be back in a few weeks. A few weeks or so later, I made an appointment to have the pitman arm replaced and the truck realigned. This was strategic on my part as it would immediately follow me replacing the front springs and shocks. I drop the car off, I pick it up and the camber looks insane. Must have been 5 to 10 degrees positive! VERY noticeable with the naked eye. I, of course, asked about the camber and was told that camber is not adjustable on the Ford twin I beam suspension. I paid my bill and went home where I did some research. Here's what I discovered... There is a camber bushing that needs to replaced on the twin I beam suspension. Correcting the camber is expensive (the bushings are about $60 each retail) but hardly impossible. Further, I learned that the pitman arm is a non-wearable item on a 95 F150. I am not seeking my money back from them. I made the mistake of trusting them and my penance is being out that money. Instead, when I say a place where I can write a review of this shop, I do. I want to tell everybody that these guys have no clue what they're doing. I didn't bring in anything bizarre or exotic, just a mid-90's Ford truck, something around 1 million of these things were built. This is not a rare car at all! This shop couldn't perform a simple task on a common vehicle and didn't know what they didn't know. Alternatively, they knew that they didn't do the job and simply lied to me.