Mechanic Advisor

Acura Repair Questions

CRUISE CONTROL PROBLEM CRUISE CONTROL STOP WORKING 2000 Acura TL

Car Model: 2000 Acura TL
Location: Atlanta, GA Submitted on February 6, 2013

Guy
Atlanta, GA

CRUISE CONTROL PROBLEM
CRUISE CONTROL STOP WORKING

Rate this Question:

Answers

  • Photo
    Eugene
    Franklin, MA
    (0) Rated this answer helpful
    Check to make sure the second brake switch to deactivate the cruise control isn't stuck on. It's near the fire wall by the top part of the brake pedal 
    Posted on February 06, 2013
    Respond
    • Guy
      Atlanta, GA
      (0) Rated this answer helpful
      2000 Acura TL
      Posted on February 06, 2013
      Respond

      Need more advice? Ask our experts.

      Other Acura Related Repair Questions
      • Anastasia
        Sedro Woolley, WA
        Water pump and timing belt
        I have been trying to fix my acura for almost 4 years for something so small that should have been a quick fix that has been changed into my worst nightmare which has lead to heart break. So my timing...
        1996 Acura TL | answers (1)
      • Shelia
        Oneonta, AL
        transmission?
        my car just stopped in the road and now it wont go forward or backwards. the wheels seem to be locking up.  Could a locked up transmission cause that to happen?  I just replaced the motor so I am into...
        1994 Acura Vigor | answers (1)
      • David
        Chantilly, VA
        e-Brake adjustment
        Recently replaced  driver side rear caliper, put new pads on, bled brakes, hooked e-brake cable back on but will not stop when e-brake is engaged. Had cables replaced a couple months ago at a local sh...
        1990 Acura Integra | answers (1)
      • Shelia
        Oneonta, AL
        wont go forward or backwards
        Car wont go forward or backwards. the wheels seem to be locking up.  Can a cv axle cause that to happen?
        srtaylor440@gmail.com
        1994 Acura Vigor | answers (0)
      • Donald
        Dallas, TX
        Pcv Valve
        Could you Please help locate the pcv valve on this car
        1991 Acura Integra | answers (2)
      • John
        Buena Park, CA
        Starter does not activate
        Can one jump start car bypassing solenoid in starter?  Just need to bring car home for repair.  I have done this on my 1985 toyota p/k!
        1997 Acura CL | answers (1)
      • steve
        Moreno Valley, CA
        Stalling
        after driving the car for awhile, it starts to feel like it want's to cut out. And it usually cranks over on the third try. Could you please help me out with this? I have the 1.8 Thank You.
        2007 Acura MDX | answers (1)
      • Gene
        San Jacinto, CA
        Starter won't disengage, have to disconnect batter...
        87 Pathfinder has been sitting for about 6 months. Went to start it, installed battery, as soon as I hooked up the battery the starter engaged; the key was still in my pocket. Disconnected the battery...
        2007 Acura MDX | answers (0)
      • Gene
        San Jacinto, CA
        Starter won't disengage, I have to remove the batt...
        87 Pathfinder has been sitting for about 6 months. Went to start it, installed battery, as soon as I hooked up the battery the starter engaged; the key was still in my pocket. Disconnected the battery...
        2007 Acura MDX | answers (0)
      • Donald
        Dallas, TX
        Fan Relay/Pcv Valve
        Radiator Fans Not Working Also Does this Car have Pcv Valve if so Where is it Located Thanks Again
        1991 Acura Integra | answers (0)